Step-By-Step
I started with a circle.
|
To make the rings of the maze I made two circles and put two lines going across them. Then I trimmed the parts between the two lines to make the ring of the maze.
|
I repeated that until I had a maze. The spacing between the walls of the maze were 0.313 inches.
|
Then I extruded the maze.
|
Finally I changed the power on the laser so it didn't put a hole through the foam.
Routing
What I Learned
During this project I learned how to set up the router and zero the point where you want the router to start. I also learned how to use the trimming tool in inventor better. Finally learned that making sure specifics are correct is important because while i made the channels of my maze the correct width some of the openings were to wide so there were pieces of foam the router didn't get.